: 302 Dual Microphone Preamplifier

Absolutely! How-to: More than three levels of paging with the Zone Mix 760 Within the offices of Symetrix, we often joke that our all-encompassing banner should actually read ‘Over-engineered by Symetrix’. We take great pride in the design of our…

Yes and no, the CLIP LED lights when the signal reaches 3dB below clipping. This LED should never be on solidly. It is usually all right if the CLIP LED flashes occasionally, on peaks in the program material. If you…

The 302 is an ultra-clean two channel dual mono preamp for use in critical digital and analog recording situations. For optimum sonic performance and lowest possible noise, route the 302's output(s) directly into the tape machine or recording device's line…

If your computer has a sound card with line level inputs (NOT microphone level!!!), use the TRS line output jack connecting the tip as (+) and the sleeve as the common or ground. However, it is recommended to have a…

If you're going directly to line level inputs of a recording device as suggested chances are it's coming from the microphone's internal capsule pre-amp, some of the older microphones sought after for their character and warmth especially the tube versions…

Check the level of the input signal on the 302's LED display. Is the CLIP light on all the time? If so, reduce the incoming signal level by turning the INPUT level counterclockwise. Is the incoming signal already distorted? Make…

302 AutoCAD file