Where can I find a Data Sheet for the 610 Broadcast Audio Delay?
610 Data Sheet
: 610 Broadcast Audio Delay
Where can I find a Flow Chart for the 610 Broadcast Audio Delay?
610 Flow Chart
Where can I find a User’s Guide for the 610 Broadcast Audio Delay?
610 User's Guide
Where can I find Schematics for the 610 Broadcast Audio Delay?
610 Schematics
Why does my 610 system level change when I switch between Operate and Bypass?
A few users are surprised with large gain increases when they install the 610 into their audio chain. Here's why. The 610 uses a balanced, bridging input. It does not present a 600-ohm load to the output of the device…
Why do I hear distortion when the 610 Broadcast Audio Delay is activated?
A level increase of this magnitude will increase the amount of compression applied by the limiter by 6 dB. This change will be noticed by anyone sensitive to the station's sound. Distortion will become evident if the input circuit of…
Why is there a high frequency roll-off while the 610 Broadcast Audio Delay builds delay?
While the 610 is building delay, the frequency response is down 1 dB at 6 kHz, 2 dB at 8 kHz and 3.5 dB at 10 kHz. Once the 610 builds its 7.5 second delay the frequency response is flat…
How do I exit delay for traffic reports and remotes on the 610?
Live traffic reports and commercial remotes require off-air monitoring and cueing. If the station broadcasts in delay, the reporter will hear his cue 7.5 seconds late which will result in 7.5 seconds of dead-air. In radio, 7.5 seconds of dead-air…
