Where can I find an Ethernet application with IP capable Symetrix products?
SymNet Remote Terminal is a UDP terminal test application for testing Ethernet-based control for Symetrix products. SymNet Remote Terminal.zip
: 8 Out
Where can I find some example Site Files for SymNet Designer?
Example Designer Site Files: Two Switches 64x64 Matrix Arena BGM Distribution BreakIn12 Routing Example Button Logic Circular Routing Example Express Church Express Room Combine Large Conference Center Reverse Compressor Voice Processor
Where can I find a Data Sheet for the 8in DSP, or 8out DSP?
SymNet Brochure (June 2004 archive)
What is the maximum recommended length of an RS-485 cable?
4000 feet is the longest recommended cable length.
What is DSP and how does to apply to Composer-based hardware?
Advanced Digital Signal Processing is at the core of our Composer-based hardware. Our solutions simply design and deliver superb fidelity, adding value for designers, integrators, and end users.
How much latency is there in a SymNet SymLink system?
This question has a three part answer since the digital signal path through a SymNet system has three different major components. Converter delay: Approximately 850 microseconds for the AD, and 624 microseconds for the DA. One DSP core: Maximum delay…
How many SymNet units can I connect together with SymLink?
There can be a maximum of 16 SymNet hardware units in a SymLink ring. This includes the 8x8 DSP, 8in DSP, 8out DSP, CobraLink, BreakIn12, Breakout12, and DigIO 12x12 DSP.
Can SymLink busses be re-used to accommodate higher channel counts?
Yes, this can get confusing so it shouldn’t be attempted until users are familiar with the SymLink architecture. SymLink is a circular bus. The transmit port from one unit is connected to the receive port of the next unit using…
Can I copy/paste DSP module settings in Designer?
Yes. Use the mouse right-click to save and load DSP module settings to and from your disk-based ‘Settings File’. The ‘Settings File’ is a library that you can use to store EQ, Compressor, Crossover, etc. setups and recall them at…
Will SymNet SymLink and Express hardware work with AMX or Crestron control systems?
Yes. There is a dedicated RS-232 port on the rear panel of all 8x8, 8in, 8out, DigIO and CobraLink units for this purpose. This port can be used simultaneously with the host computer connected to the front panel RS-232 port,…
