Where can I find a Quick Start Guide on the BreakOut 12?
BreakOut 12 Quick Start Guide
: BreakOut12
Where can I find a Data Sheet on the BreakOut 12?
BreakOut 12 Data Sheet
Where can I find an Ethernet application with IP capable Symetrix products?
SymNet Remote Terminal is a UDP terminal test application for testing Ethernet-based control for Symetrix products. SymNet Remote Terminal.zip
What is DSP and how does to apply to Composer-based hardware?
Advanced Digital Signal Processing is at the core of our Composer-based hardware. Our solutions simply design and deliver superb fidelity, adding value for designers, integrators, and end users.
Where can I find the External Control Protocol for SymNet SymLink, Express, and Solus units?
The External Control Protocol for SymNet units can be found below. This document covers all third-party control for SymNet units including both RS-232 and UDP (IP). SymNet External Control Protocol
How much latency is there in a SymNet SymLink system?
This question has a three part answer since the digital signal path through a SymNet system has three different major components. Converter delay: Approximately 850 microseconds for the AD, and 624 microseconds for the DA. One DSP core: Maximum delay…
How many SymNet units can I connect together with SymLink?
There can be a maximum of 16 SymNet hardware units in a SymLink ring. This includes the 8x8 DSP, 8in DSP, 8out DSP, CobraLink, BreakIn12, Breakout12, and DigIO 12x12 DSP.
Can I talk to Composer-based DSPs using HyperTerminal?
If the unit has RS-232 control, yes. HyperTerminal can be used to simulate an external controller. Default settings: Baud: 38400 Data bits: 8 Parity: None Stop bits: 1 Flow control: None
Where can I find specifications or a Data Sheet for the CobraNet and SymLink SymNet line?
A Full Line SymNet Product Catalog complete with specifications can be found below. Additional installation information and/or specifications may be found in each product's Quick Start Guide (if applicable). SymNet Full Line Product Catalog (EN)
What is the maximum voltage recommended for the analog control inputs on a SymNet device?
The input stage of an analog control input of a SymNet device will clamp on an input exceeding +5.5V. Anything above +5.5V will draw excessive current (the amount depending on the output resistance of the device supplying the current) and could possibly…
