Frequently Asked Questions
Select a Category
Knowledge Base > Discontinued Products > 8×8 DSP
Are Crestron modules available for Composer?
The following archive contains Crestron modules for the most commonly controlled functions of Composer:
The v3.0 Crestron modules are compatible with Composer hardware including Edge, Radius 12×8 EX, Radius AEC, Prism, Solus NX, xControl, 2 Line Analog Telephone Interface Card, and the 2 Line VoIP Interface Card. The following control modules have been developed and will be available for use with the Crestron 2 and 3 series controllers:
- Volume Up/Down Control Module with User Limits
- Fader Set Control Module
- Button Push Module
- Preset Execution Module
- Controller Receiver Module
- Input / Output Selector Module
- VoIP Dialer Module and ATI Dialer Module
- Speed Dial Module / Speed Dial Store / Delete Phone Number / Name Module
The updated Crestron modules utilize command processor architecture to maximize efficiency and responsiveness. The command processor is responsible for all the data parsing to and from the Symetrix DSP which makes it more efficient for the individual control modules to operate. When the control ID’s match a particular control module, then the controller information is used and updated.
Note: Crestron v.3.0 modules were specifically designed to work with SymNet Composer hardware over RS-232 (baud rate 57600), TCP/IP or UDP/IP port 48631. These modules will not work with legacy SymNet hardware. If you have legacy SymNet hardware, please use the Crestron v.1.0 or 2.0 modules.
The v2.0 Crestron modules are compatible with SymNet Composer hardware including Edge, Radius 12×8, Radius AEC, Prism, Solus NX, xControl, SymNet 2 Line Telephone Interface Card. Examples provided include Fader control, Button press, Increment and Decrement button, Preset Recall, Mute All, and Controller Receiver.
Note: Creston v2.0 modules where specifically designed to work with SymNet Composer hardware over RS-232 (baud rate 57600) or UDP/IP port 48631. These modules can also be used for UDP/IP control with legacy SymNet hardware, Integrator Series, Jupiter Series, and Solus by simply changing the RS-232 buad rate to 38400 or the UDP/IP port to 48630.
This program was created to demonstrate the capabilities of the SymNet 2 Line Analog Telephone Interface (ATI) card in the context of Crestron external control.
The user module and touch panel signals that comprise 95% of this program can be easily copied to other integration projects where the Symetrix ATI card will be used.
A Composer file has been created that has the controller numbers corresponding to this external control program. This allows the correct information to flow in both directions between the device and control system processor.
The v1.0 Creston modules are compatible with: Jupiter, Zone Mix 761, 780, 788, 722, Solus, 8x8DSP, CobraLink, and 4×4, 4×12, 8×8, 12×4 Express Cobra hardware), Examples provided include Volume, Fader, Button, Switch and Dialer control plus Preset recall. Additionally, the v1.0 modules will work with the legacy SymNet hardware across a multi-unit ring, as well as a multi-ring system.
A matching example SymNet Designer Site File is also included. The modules are fully documented by the SymNet Control Protocol Crestron Module.
Addendum linked here: SymNet_Control Protocol_Crestron_Module_Addendum