Frequently Asked Questions

Select a Category

Knowledge Base > Dante Networking Solution

We are using Dante now for 2 years without Problems. We have a Gigabit Network here, but some amps have a 100mbit Network Connection, so we set all dante devices @ 1ms latency. Would it be possible to Change that down to 250µs and only the 100MBit amps at 1ms?

Simple answer: yes, it is possible. Latency is configured per receiver and is not required to be a single value for the whole network. You can set the receive latency on the amplifiers to 1ms and the latency on 1Gbps devices to lower than 1ms.

We recommend using the new Dante Controller latency monitoring feature to confirm that it is safe to lower the latency in your 1Gbps network and/or to verify your latency headroom when you have done so.

How can we help?
Twitter
LinkedIn
Instagram