-
Type
- Dante
- Networking
- Control
-
System Management
- Composer Management Software
- SymVue Screen Authoring
- AV-Ops Center Remote Monitoring
- ARC-WEB Control Interface Signal Processing
- D100 AVoIP DSP Server
- Radius NX AVoIP DSP
- Prism AVoIP DSP
- Edge AVoIP DSP
- DSP I/O Expansion Cards
- Jupiter DSP
- Zone Mix 761 DSP I/O Connectivity
- xIO Bluetooth Endpoints
- xIO XLR Endpoints
- xIO AVoIP DSP Audio Expanders Control Systems
- T-Series Touchscreen Controllers
- W-Series Controllers
- Control Server for Personal Devices
- xControl GPIO Expander
- ARC-Series Controllers
Edge AVoIP DSP
Do Edge Frames, when Dante is daisy chained, need to be looped back into a ring configuration like SymLink?
Edge units are daisy chained, and not a ring configuration. In an Edge system the last unit should not be connected directly to the first unit, rather just daisy chaining them creates the entire Dante network, as each Dante port is truly its own Gigabit network switch.
Does a Edge frame have enough processing for to support a xIn 12 or xOut 12?
Absolutely, the Edge has enough processing to support two xIO devices in most cases. In heavy laden DSP applications, it may be preferable to use only one xIO per Edge.
How much processing does an Edge frame contain?
An Edge frame utilizes a 400Mhz SHARC processor for DSP.
If 8 channels of Dante audio are sent from one Edge Frame, does that mean that the second frame in the system now has only 56 channels of Dante left to transmit on, similar to how SymLink shared 64 channels amongst the entire ring?
Each Edge unit uses a Brooklyn card which gives each Edge unit 64◊64 discreet Dante inputs and outputs. This is not a shared number between units, as a total of 1024 channels can live on a Gigabit network at one time, such as in the case that 16 Edge frames are all transmitting 64 unique channels of Dante.
How is the RS-232 port on Edge used?
RS-232 is a standardized protocol for serial communication. Edge can talk to 3rd party controllers and devices on the RS-232 network using simple ASCII control strings.
Does Edge contain local GPIO or is a control accessory, such as the xControl needed?
Yes, the Edge does have local GPIO so the xControl is not needed in most cases. The Edge frame has 8 analog control ports (8 pots or 16 switches) and 8 Logic Outputs.